|
This is the cb i picked up off TRS.
Its
a
Cobra WX ST
II. The installation of it is very simple, and only
took me about 10 minutes from start to finish.
|
|
Since i dont smoke, i
opted to remove the ash tray and install the CB in its place. I
used the power leads for the cigarette lighter for the CB. This
way i didnt even have to run any wires through the dash! There was
some modification made to the dash, as the CB was about a half inch
wider than the tray, but it is only noticeable when the CB is removed.
|
|
I used the
bolts that hold the tire carrier to hold the antenna hangar in place,
just had to drill two holes in it that lined up with the carrier
hinge. I ran the wire along the inside of the frame rail where it
would be safe.
|
)
)